Trace resulting from the difference between two
traces
It is possible to obtain the trace corresponding to the point-by-point difference between
the current trace and the trace in overlay (if only two traces are displayed simultane-
ously). To do this:
1
Press Advanced > Overlay menu keys
2
Press the
The screen displays the 2 traces in overlay and the trace resulting from "Differ-
ence".
Removing a trace in overlay
Removing the current trace
It is possible to remove a trace displayed. To do this:
1
Select it (see previous paragraph),
2
In Results page, press Advanced > Overlay menu keys
3
Press
Removing all the traces
To remove all the traces except the current trace, press the key
Quitting the overlay menu
To quit the overlay menu, press the
Table of results
Lines
According to the choice made in the S
•
either a line for each channel detected (if Channel Selection = Permanent)
•
or a line for each graduation, (if Channel Selection = Grid and a grid is selected)
2 Curves Diff.
Remove Current
Trace.
User Manual
Chapter 8 Optical Spectrum Measurement
menu key.
Exit
key.
menu, the table of results may include:
ETUP
78000010220 Rev. 024
Table of results
Remove Other
Traces.
271