Table of Contents
Advertisement
Chapter 5 Power meter and Source functions of the OTDR Modules
Storing and reloading results
The reference levels are stored into the unit, and have been automatically filled into the
setup.
Measurements on the fiber under test
Once the references have been performed on both units:
1
After a reference in loopback mode, disconnect the jumper from the powermeter
port on the MTS / T-BERD 8000 V2 (1) and the jumper from the Source port on
the MTS / T-BERD 8000 V2 (2).
After a reference in Side by side mode, disconnect the bulkhead connector and
keep the jumpers connected to the Source and Powermeter ports.
2
Connect the jumpers to the fiber under test using the appropriate method (ex.
keying mechanism for FC/PC types).
3
On MTS / T-BERD (1) select Laser On to activate the light source.
Figure 115
Measurement of the fiber under test
OTDR Module:
Source port
MTS / T-BERD 8000 V2 (1)
Storing and reloading results
File Setup
Click on the button
management"
Storing results
In order to save the results of a measurement, click on
files are being saved:
192
A popup message appears once done. Press any key to continue
F
to access the
ILE
for a complete description of all parameters, options and the explorer.
User Manual
Fiber Under Test
Jumper
MTS / T-BERD 8000 V2 (2)
File
setup. See the chapter
78000010220 Rev. 024
Mainframe
Power meter
port
Chapter 20 "File
F
and select
Store
ILE
trace. Two
Advertisement
Table of Contents
Troubleshooting
