Reference; Alarms Parameters - Viavi 8100 V2 Series User Manual

Power Level
This parameter enables to get a power level indication at the start of an acquisition (only
with 81DISPAP or 81MRDISPAP modules).
No
Yes
NOTE
If Yes is selected, the acquisition stops if not enough power is received.

Reference

Last Reference / BBS Type / BBS Serial Number
These parameters provide the relevant information related to the Broadband source
(BBS) referencing.
These parameters cannot be modified as they are automatically generated after a refer-
ence measurement (see

Alarms parameters

In the Setup page, press Alarms softkey (if one parameter is selected in the current
screen, press Top Menu soft key to display the right menu keys and click on Alarms).
Alarm Status
None
Active
Auto Values: Yes
The maximum dispersion tolerance is automatically set according to the bit rate informa-
tion.
Bit rate info.
List all relevant data rates. Use the direction arrow keys
Chapter 14 CD measurements using phase shift method
the received power is not indicated before starting the measurement
acquisition.
the received power is indicated at the beginning of measurement.
"CD Reference measurement" on page
No alarm management.
Enable the Pass/Fail evaluation according to the defined thresholds
(see below).
User Manual 78000010220 Rev. 024
Configuring the CD test
435).
and for selection.
431