Table of Contents
Advertisement
Chapter 3 Reflectometry measurements
Saving the trace(s) and generating a report
•
No reference trace(s) defined: all the «standard» traces are removed and only the
new trace acquired is displayed.
Using the reference trace function in the explorer
A trace stored in memory can be set as reference trace before loading one or several
«standard» trace(s).
To open one or several reference trace(s)
1
Go on the File Explorer
2
Select the trace(s) to be defined as reference
3
Click on Load and select Reference = Yes on the key
4
Click on View Trace(s) or Load Trace + Config.
The trace(s) open(s) and the icon
the results table.
To open «standard» traces to be added to the reference ones
5
Go back to the explorer
6
Select the trace(s) to be opened in the same screen as the reference trace(s)
7
Click on Load and select Reference = No on the key
8
Click on View Trace(s) or Load Trace + Config.
Saving the trace(s) and generating a report
Once the results page is displayed, the trace(s) can be saved and, in Expert Mode only,
a report can be generated directly from the results screen.
In Expert mode, the traces saving and report generation can have already been
performed automatically if the parameter Auto Store was defined on Yes in the Setup
screen (see
txt or + pdf).
Saving results in Smart Test mode
Once the results page is displayed, cick on the menu key Save
100
"Auto Store" on page
User Manual
appears on the upper right hand part of
51) with the appropriate Save Mode (file only or file +
78000010220 Rev. 024
.
Advertisement
Table of Contents
Troubleshooting
