Figure 31
Acquisition in progress with Expert OTDR
Elapsed
acquisition time
At the end of the acquisition, a beep is emitted, the trace is displayed and an automatic
measurement is started.
NOTE
During acquisition, the traffic on fiber is automatically detected (see
Detection" on page
NOTE
To stop the acquisition, the S
Then an automatic measurement is carried out, but some events cannot be
detected (a manual measurement must then be made).
Performing an acquisition from Results page
Once the results page is displayed, you can perform a new acquisition modifying the
main acquisition parameters.
Number of averages
calculated
56).
User Manual
Chapter 3 Reflectometry measurements
Performing OTDR acquisitions
Elapsed
time
/S
key may be pressed at any time.
TART
TOP
78000010220 Rev. 024
Total acquisition
time
"Traffic
61