Laser Safety; Cleaning Of Connectors; Transportation - Viavi 8100 V2 Series User Manual

Laser safety

The OSA module contains a Class 1 Laser product according to DIN EN 60825-1.
Please take notice of following instructions

Cleaning of Connectors

Cleaning of the patchcord connector is extremely important to avoid damage to the input
of the OSA. A dirty connection can irreversibly damage both surfaces, especially when
working with high powers.
We highly recommend inspection of the patchcord before connecting it to the OSA

Transportation

The OSA can be damaged by excessive acceleration during transpor-
tation with improper packaging.
Modules without a MTS / T-BERD should be shipped only in the origi-
nal packaging.
For shipping of a MTS / T-BERD 6000(A) or MTS / T-BERD 6000A V2
containing an OSA, use either the original packaging with the black
rubber foam, or the transportation case referenced E60HCASE-OSA.
For shipping of a MTS / T-BERD 8000 V2 containing an OSA, use either
the original packaging with the black rubber foam, or the transporta-
tion case referenced E80HCASE-OSA.
Using the original packing material ensures that the device is properly
protected during shipping. Otherwise, Viavi cannot give warranty on
modules good protection.
If you need a new packaging, please contact Viavi Technical Assis-
tance Center.
When the system or device is switched on, never look directly into the in-
and output or into a connected optical fiber.
The devices which are tested can be rated in a higher laser class with
dangerous radiation. Observe their security instructions. Please heed the
normal precautions for working with lasers and consider local regulations.
User Manual
Chapter 8 Optical Spectrum Measurement
78000010220 Rev. 024
Laser safety
245