Table of Contents
Advertisement
On Setup page, select one of the menu clicking on one of the menu key or press Main
Menu to display the menu keys on the right of the screen.
The various parameters proposed are defined below.
Loading a configuration file
To load the configuration file to be used for OSCA test:
1
Press S
ETUP
2
On bottom right of setup page, press Load Config. menu key.
3
In the Explorer, select the desired file configuration
4
Press
Load
A beep is emitted to validate the selection of the configuration file.
The software automatically brings you back to setup page.
NOTE
Most of the configuration files are available into the Platform in disk/config/
OSA.
Acquisition Parameters
Mode
WDM / OSNR
POL-MUX
Sweep Range
Select the wavelength numbers or Full parameter to use all wavelengths available.
Chapter 9 OSCA-710 Optical Spectrum Measurement
hard key.
Config. menu keys.
Module is used for measuring the OSNR by using the
standardized analysis method. This mode is recommended for
OSNR measurements on signals without optical filtering.
This setup is used for polarization multiplexed carriers. The
OSNR of the signal is calculated with a spectral correlation
method on active links. See
mulitplexed ) channels" on page
User Manual
OSCA optical spectrum analyzer Setup
„"Measuring POL-MUX (polarization
328.
78000010220 Rev. 024
311
Advertisement
Table of Contents
Troubleshooting
