Commands Of The Power Meter Parameters - Viavi 8100 V2 Series User Manual

Chapter 5 Power meter and Source functions of the OTDR Modules
Result page
Figure 111 Results and commands of the power meter

Commands of the power meter parameters

When the Powermeter function is selected, the following softkeys are available on the
results page:
The different configuration buttons are displayed:
Wavelength
Unit
Zero
On the results page, the following actions are available:
Standard Reference
Keep Result
Clear Table
If the Source function is selected (either on this Platform, on the base Unit or on an
OTDR module, or on another Platform), the Power meter results page is different:
• The Wavelength, Unit and Zero menu keys are accessible via the menu key
Power Config.
186
Selection of the wavelength
Choice of the unit
Adjustment of the Zero value when the power meter's optical input is
closed with a plug (a validation is required).
Selects the current result as reference value to measure the attenua-
tion of a link. This reference is displayed under the measurement
result until a new reference value is chosen.
Saves the result on the corresponding line of the table.
Deletes all the results recorded in the table.
User Manual 78000010220 Rev. 024