Table of Contents
Advertisement
Chapter 3 Reflectometry measurements
Enterprise-SLM Software option (T-BERD/MTS-6000A V2 only)
Figure 60
Example of Project
The icon
Click on the label to open the sub-menu where the fiber numbers are displayed.
Note; This sub menu cannot be opened for Simplex mode as 1 label corresponds
to 1 fiber.
Disable a test
Before starting the test, some fibers can be disabled so that the acquisition will not be
performed. on those
1
Select the fiber number which does not need to be tested (underlined).
2
Click on the soft key Disable fiber test.
3
Repeat the process for the fibers which do not have to be tested.
118
displays on the upper banner, indicating a project is opened.
User Manual
78000010220 Rev. 024
Advertisement
Table of Contents
Troubleshooting
