Ftta Setup - Viavi 8100 V2 Series User Manual

Figure 71 FTTA OTDR Setup
See OTDR Setup:
"Configuring the Link
parameters" on page 43

FTTA setup

In the first screen, configure the following parameters:
Laser
• The acquisition will be carried out on the wavelength(s) selected (for multiple-
wavelength modules). In case of a multi-wavelength module, select All to perform
a measurement for all the wavelengths available (this parameter visible
exclusively on modules with one single OTDR port). The possible values depend
on the module used.
Network Config. (see
This parameter is used to identify the network type.
Cell Tower
Rooftop Tenant
Rooftop Penthouse
Das
page 130)
Typical macro cell tower topology
Rooftop topology
Rooftop topology
Distributed Antenna System
User Manual
Chapter 3 Reflectometry measurements
78000010220 Rev. 024
FTTA-SLM option
129