Automatic Configuration - Viavi 8100 V2 Series User Manual

Filenaming
Select Filenaming parameter and press the right arrow key to modify the name of the
file for the result trace.
In the edition keypad, select the pre-defined parameters available or, press abc
key to enter a name manually for the file. Then, press Enter to validate..
Figure 130 Filenaming - Edition keypad (pre-defined parameters)
or
Press Default Filename to apply the name by default to the file:
If the parameter Table View is defined on Fiber: [Fiber_Id][Fiber_Num]
If the parameter Table View is defined on Cable: [Cable_Id]
See "Table View" on page
As soon as the Cable Id changes, the result table is cleared and the next tests are
stored with the new Cable Id name.
The name of the file is displayed in grey under Filenaming parameter

Automatic configuration

Press the key Auto Setup to configure automatically the acquisition parameters as
follows:
• Lasers: All
227)
User Manual
Chapter 7 FiberComplete Modules
78000010220 Rev. 024
Configuring the units
229