Changing The Name Of An Event - Viavi 8100 V2 Series User Manual

Merged connectors
When 2 or more connectors are very close to eahc others (in the attenuation dead zone),
usually the reflectances can be measured but the loss of the individuals can't be - the
loss of these connectors is "merged"
The following formula is then applied (only in FTTA mode):
loss per connector = (total group loss) / (nb of connectors in the group)

Changing the name of an event

Once the SmartLink screen is displayed, the name of an event can be modified:
1 Select the event to be modified (highlighted in yellow)
2 Press Rename Event menu key
3 In the edition keypad, enter a new name for the event.
Figure 80 Rename Event
4 Click on Enter to return to Event View.
The event name is displayed under the icon, and replaces the previous FTTA
label
Click on Replay Label to rename the event as it was previously (at last saving).
.
User Manual
Chapter 3 Reflectometry measurements
.
78000010220 Rev. 024
FTTA-SLM option
.
141