Figure 116
OEO test setup menu
See OTDR Setup:
"Configuring
the Link parameters" on page 43
Acquisition parameters
Laser
Acquisition
Alarms parameters
The alarms apply to the measurements average, and not to the measurements for each
side (as it is in the classical OTDR mode)
See OTDR Setup:
"Configuring the
Alarms parameters" on page 36
Acquisition will be performed on all selected wavelengths, as long as
they are available on the remote OTDR as well. If not, acquisition will
be performed on all wavelengths selected and common to both
OTDRs. Please see the recommendation on
the same type of OTDR)
Bi-directional measurement allows manual and Auto modes only.
Operation is the same as for OTDR measurement.
User Manual
Chapter 6 Bi-directional OTDR
Configuration of bi-directional measurement
See OTDR Setup:
the Analysis parameters" on
page 38
See OTDR Setup:
the File parameters" on
page 48
78000010220 Rev. 024
"Configuring
"Configuring
page 196
about using
199