Table of Contents
Advertisement
Figure 121
Configuration for FiberComplete function
Acquire
Measure Bidir IL & ORL
and OTDR
NOTE
The FiberComplete function can be performed with one T-BERD/MTS-8000
V2 and one T-BERD/MTS-6000/6000A.
Configurations
Two configurations are available, depending on the tests that have to be performed:
•
Construction/Installation tests with loss, optical return loss, distance and OTDR.
•
Acceptance Tests with loss, optical return loss and distance, and faults detection
in case of problem.
Construction/Installation Test
In this configuration, bidirectional IL and ORL, length and/or unidirectional/bidirectional
OTDR measurements are performed. The bidirectional IL/ORL and length results are
stored on each unit, the OTDR traces are stored on the primary unit (where the test has
been initiated*) in unidirectional mode, and on both units in bidirectional mode.
Local
IL / ORL /
Analyze
Locate failures with
Fault Finder
User Manual
Chapter 7 FiberComplete Modules
Remote
Distance /
Report
Save all the results
automatically
78000010220 Rev. 024
General introduction
217
Advertisement
Table of Contents
Troubleshooting
