Chapter 3 Reflectometry measurements
Activating the OTDR function
Activating the OTDR function
Once the OTDR module is correctly set onto the equipment and the T-BERD/MTS is
switched on, the desired OTDR function must be selected before any OTDR configura-
tion, or measurement.
Selecting the Smart Test function
Principle of the Smart Test
The Smart Test is used to perform OTDR acquisitions using a pre loaded configuration
file (no setup required) and access to essential analysis features.
Selecting Smart Test
The Smart Test function is available whatever is the OTDR module set onto the T-BERD/
MTS.
To select this function, after the equipment starts:
1
Press the H
Figure 14
Home page
2
Select the Smart Test icon
26
button.
OME
User Manual
78000010220 Rev. 024