Viavi 8100 V2 Series User Manual page 254

Chapter 7 FiberComplete Modules
General introduction
Figure 122 Construction/Installation Test
Acceptance Tests
In this configuration, the bidirectional IL, ORL and length measurements are performed
and results are automatically stored on each unit.
If the Fault Finder function has been selected in the Setup menu, and if at least one
result exceeds the defined thresholds, the predominant defects causing the failure are
identified and located.
The FiberComplete screen displays an easy to interpret result table that prompts
predominant issues for easy troubleshooting.
218
Reference Source and power meter
on Units A & B
Setup Units A & B
(Measurement and File parameters)
S /S
Press
TART TOP
measurements
Measure loss A->B, B->A, and Avg and
store/display on both units
Measure ORL A & ORL B, and
store/display on both units
Do an OTDR measurement and store
it on the unit
User Manual
button to launch the
78000010220 Rev. 024
Next
Fiber