Table of Contents
Advertisement
Installing a module in a receptacle and removing it
With the T-BERD/MTS-8000 V2, a module may be inserted into either of the two slots
provided for the purpose. With the T-BERD/MTS-6000/6000A, only one module may be
installed into the Platform.
When a slot is vacant, it is closed by means of a cover-plate fitted with two captive
screws like those on the plug-ins.
Figure 7
Rear view of the 8000 V2 Platform (example)
Inserting a module
The Platform must be switched off, and if it has a mains power supply, the
adapter cable must be unplugged
1
Slide the module into its slot.
2
When it is fully home, press against the screen-printed surface of the module
while tightening the securing screws. The screen-printed surface of the plug-in
must be flush with that of the receptacle.
3
Make sure that the two large captive screws of the plug-in are screwed fully
home.
Installing a module in a receptacle and removing it
Captive screws securing the
User Manual
78000010220 Rev. 024
Chapter 2 Getting started
15
Advertisement
Table of Contents
Troubleshooting
