Table of Contents
Advertisement
A measurement result is displayed in the table when the
pressed.
The
Clear Table
If the Alarm function has been activated, any result that exceeds the selected thresholds
appears in red in the table. Otherwise, results are shown in the table in green.
When the instrument is switched off, results present in the table are saved.
Figure 257
Results and commands of the LTS
Results
of the
power meter
Commands
When the LTS function is selected, the following softkeys are available on the results
page:
Source Config. See
Powermeter Config.
–
Wavelength: Modify the signal wavelength
–
Unit: Modify the unit selected
–
Zero: Adjustment of the Zero value when the power meter's optical input is
closed with a plug..
softkey orders deletion of all the results displayed in the table.
"Configuring and displaying the parameters of the source" on
page 501
User Manual
Keep Result
78000010220 Rev. 024
Chapter 18 OFI Module
LTS function
softkey is
503
Advertisement
Table of Contents
Troubleshooting
