Table of Contents
Advertisement
Main display zone
The central zone of the screen can display the configuration of the instrument or the
measurement, the memory explorer of the Platform , the measurement results, etc.
Refer to the chapter dealing with the measurement in progress.
Tabs
When the instrument performs several different functions (OTDR, PMD, Power Meter,
etc.), the various configuration or results pages are accessible from tabs. To change
from one tab to another, the button selecting the page must be pressed. For example:
•
on the Results page, to change from one tab to the other, press the
button
•
on the measurement configuration page, to change from one tab to the other,
S
press the
•
On the file configuration page, to change from one tab to the other, press the
F
button.
ILE
NOTE
There is a tab for each different type of measurement: OTDR SM, OTDR
MM, OSA, Power Meter... The tab of a function is displayed if and only if a
module corresponding to this type of measurement has been inserted in the
instrument, or if a file of the type of this measurement is open. If two modules
of the same measurement type are present, then only one module is
"active", so only one tab will appear for this measurement. To change the
active module, go to the Home screen and select it there.
A small icon may appear in the left corner of each tab, according to the status of the
corresponding module.
The icon signification is the following:
•
No icon: the function is used in a read-only mode (no module), or the module has
not been selected.
•
Dark green icon: the function has been selected but the corresponding module
does not currently perform an acquisition.
button
ETUP
User Manual
78000010220 Rev. 024
Chapter 2 Getting started
Display screen
R
ESULTS
23
Advertisement
Table of Contents
Troubleshooting
