Testing Next Fiber - Viavi 8100 V2 Series User Manual

Fiber Characterization Automated Test Sequence using the Link Characterization Script
All measurements are completed FOR THIS FIBER

Testing next fiber

Before testing next fiber, make sure the fiber description (fiber num-
ber, location...) has been correctly setup in the FiberComplete FILE
setup page and copied to all.
On the T-BERD/MTS 8000 V2
1 Go to MTAU tab and select Out A
On the T-BERD/MTS 6000A V2
1 Press the S
2 Activate 2 test functions:
3 Repeat steps 1 to 20 above.
Fiber Characterization Automated Test Sequence
using the Link Characterization Script
Fiber Characterization with FC1 Test Kit
(Unidirectional)
Once the referencing measurements have been done, a fiber characterization test can
be performed, using a T-BERD 8000 V2 at one end and a OBS5x0 at the other end.
Selecting data storage directory
1 Press the F
2 Press File/Explorer softkey to select the "Explorer" page.
3 Using the navigation keys or touchscreen, on the left side of the screen, select
the main or sub directory where you wish to store files, typically the "Hard Disk".
4 If necessary, create a new directory to store the results: see
directory" on page
hard key on the 6000A
YSTEM
hardkey.
ILE
474.
User Manual
Chapter 17 Fiber Characterization
/
78000010220 Rev. 024
"Creating the storage
479