Configuration Of Files Parameters; Performing A Bi-Directional Measurement; Process Display - Viavi 8100 V2 Series User Manual

Chapter 6 Bi-directional OTDR

Performing a bi-directional measurement

Configuration of files parameters

To access the files configuration menu of the OEO-OTDR tab, press the button F
Related parameters are then displayed.
All parameters to describe the files, the fiber and the link are proposed in order to save
all measurements. Please refer to
differences are presented in this chapter.
File Content
This option allows to choose to save a bi-directional measurement under two different
formats (see
One Trace
All Traces
One and All Traces
NOTE
For best use, it is recommended to use the auto file naming (with fiber code,
origin, end, lambda, fiber name and auto-store). These parameters are
applied on the master MTS/T-BERD.
Performing a bi-directional measurement

Process Display

The Process page displays the bi-directional measurement steps, the Curve page
displays the traces and results and the
results in a table (and the alarms result if alarms have been configured in the
page).
In order to display the Process page, make sure you are currently under the OEO-
OTDR tab, and press the key R
200
"Recalling OEO traces" on page
The bi-directional measurement is saved in two different
«.SOR» files
The bi-directional measurement is saved in a single file
«.OEO».
Both the .OEO and the two .sor files will be saved.
ESULTS
User Manual
"Configuring the File parameters" on page
213):
Summary page displays a summary of the
.
78000010220 Rev. 024
.
ILE
48. Only
Setup