Loading A Configuration File; Acquisition Parameters; Acquisition - Viavi 8100 V2 Series User Manual

Chapter 14 CD measurements using phase shift method
Configuring the CD test
The configuration parameters of the CD test are described below.

Loading a configuration file

To load the configuration file to be used for CD test:
1 Press S
2 On bottom right of setup page, press Load Config. menu key.
3 In the Explorer, select the desired file configuration
4 Press
A beep is emitted to validate the selection of the configuration file.
The software automatically brings you back to setup page.
NOTE
Most of the configuration files are available into the Platform in disk/con-
fig/CD.

Acquisition parameters

Acquisition

Acquisition band (with 81DISPAP modules)
OESCL
SCL
NOTE
In case of OBS5xx handheld sources, the measurement will be performed
exclusively on SCL band.
430
hard key.
ETUP
Load Config. menu keys.
measurement performed over the full wavelength range (OESCL
bands).
measurement performed over a wavelength range limited to S,C and
L bands.
User Manual 78000010220 Rev. 024