Table of Contents
Advertisement
Figure 179
I-PMD Test Setup menu
See OTDR Setup:
the Link parameters" on page 43
Loading a configuration file
To load the configuration file to be used for IPMD test:
1
Press S
2
On bottom right of setup page, press Load Config. menu key.
3
In the Explorer, select the desired file configuration
4
Press
A beep is emitted to validate the selection of the configuration file.
The software automatically brings you back to setup page.
NOTE
Most of the configuration files are available into the Platform in disk/con-
fig/IPMD.
"Configuring
hard key.
ETUP
Load
Config. menu keys.
User Manual
See OTDR Setup:
"Configuring
the File parameters" on page 48
78000010220 Rev. 024
Chapter 11 I-PMD Measurement
I-PMD Activation and Configuration
359
Advertisement
Table of Contents
Troubleshooting
