Viavi 8100 V2 Series User Manual page 110

Chapter 3 Reflectometry measurements
Results display
When the cursor function is selected, the keys
Cursors information
The information related to cursors are displayed exclusively when the Cursor function is
selected (menu key
Above the trace are shown the co-ordinates of the points of intersection of the cursors
A and B with the trace, together with the distance between the two points.
Figure 40 Cursors information
NOTE
The cursors information are displayed in the report when the Cursor function
is selected (active key). If the cursors values must not be displayed in the
report, select another softkey than the Cursor one before performing the
report (softkey Trace or Zoom for example).
Cursor and Zoom
If the Cursor key is selected, press the validation button (
automatic zoom until the fiber end or until the end of the range (Range parameter
defined in the configuration screen).
This will modify the cursors position, which will be positioned automatically at the begin-
ning and at the end of the link (taking into account the possible launch cables).
74
selected).
User Manual
and
The Cursor function is
not selected
The Cursor function is
selected
78000010220 Rev. 024
move the trace vertically.
or E ) to perform an
NTER