Configuring the Reflectometry test for FTTH network
Once the OTDR module is set into the T-BERD/MTS, and the FTTH-SLM license
installed:
1
Select the FTTH-OTDR icon
The results page automatically displays.
2
Press S
network.
Figure 82
FTTH OTDR Setup
FTTH setup
In the first screen, configure the following parameters:
Laser
The acquisition will be carried out on the wavelength(s) selected (for multiple-wave-
length modules). In case of a multi-wavelength module, select All to perform a measure-
ment for all the wavelengths available (this parameter visible exclusively on modules
with one single OTDR port). The possible values depend on the module used.
•
OLT: Optical Line Terminal (switch at the Central Office)
hard key to display the OTDR configuration screen for FTTH
ETUP
User Manual
Chapter 3 Reflectometry measurements
.
78000010220 Rev. 024
FTTH-SLM Software option
143