Saving Configuration In A File - Viavi 8100 V2 Series User Manual

Chapter 8 Optical Spectrum Measurement
OSA optical spectrum analyzer Setup
• Wavelength in nm
Table Content
Standard
Statistics
Pass/Fail
CWDM
See "WDM-Expert Software option" on page 289
Extended or User Defined parameter.

Saving configuration in a file

Once parameters have been configured, they can be kept in memory and saved in a
configuration file.
This configuration file can then be recalled in order to be recalled for future OSA acqui-
sitions.
To save parameters in a configuration file:
1 If necessary, press S
2 Select one parameter in one of the setup page (acquisition, link..)
3 Press Save Config. menu key
4 Enter a name for the configuration file using the edition keypad (max 20 charac-
ters).
NOTE
Configuration file is saved in the directory disk/config/OSA.
260
The result table displays the columns Ch-Number, Ch-ID,
Wavelength/Frequency, Spacing/Offset, Ch-Power, OSNR,
Noise
The result table displays the columns Ch-Number, Ch-ID,
Wavelength/Frequency, minimum Wavelength/Frequency,
maximum Wavelength/Frequency, Ch-Power, minimum Ch-
Power, maximum Ch-Power
The result table displays the columns Ch-Number, Ch-ID,
Wavelength/Frequency, Spacing/Offset, Ch-Power, OSNR,
Pass/Fail result
The result table displays the columns Ch-Number, Ch-ID,
Wavelength, Spacing/Offset, Ch-Power
to return to Setup page.
ETUP
User Manual
to configure the Table Content with
78000010220 Rev. 024