Chapter 3 Reflectometry measurements
Configuring the reflectometry test
NOTE
In the case a Singlemode/Multimode module, one line contains the Multi-
mode icons and a second one the Singlemode icons.
To distinguish both modes, multimode icons contain the MM mark.
Configuring the reflectometry test
Configuring the unit for Smart Test
Once the Smart Test icon is validate, press S
Smart Test standard process
1
Select the configuration file, which contains all acquisition parameters and file
storage setup, and which has been created in Expert mode (see
configuration in a file" on page
2
Configure / modify some parameters before starting the test.
3
Start the acquisition (standard or real time)
4
Save the results
Figure 15
Standard Smart Test Process
1.if an OTDR module is installed
28
53).
Load a test config
Set basic
parameters
START SmartLink
acquisition
Read measurement
pass/fail verdct
User Manual
.
ETUP
Save results
78000010220 Rev. 024
1
"Saving OTDR