Viavi 8100 V2 Series User Manual page 512

Chapter 17 Fiber Characterization
Fiber Characterization Test Sequence in Manual mode
Setting the OTDR test parameters on both units
1 Go to the SM-OTDR tab.
2 Press the soft key Alarms.
3 Select Alarm level to Fail
4 Set the thresholds to Default or define your own criteria (see
page
Setting the PMD test parameters on T-BERD/MTS 8000 V2
1 Go to the PMD tab
2 Press the soft key Test Auto.
3 Under the 'Display' section, tap "Alarms" field and define the transmission bit
rate
Figure 238 PMD Alarm configuration
Setting the AP test parameters on T-BERD/MTS 8000 V2
1 Go to the AP tab
2 Press the soft key Test Auto
Setting the CD test parameters on T-BERD/MTS 8000 V2
1 Go to the CD tab
2 Press the soft key Test Auto
3 Under the Display section:
–
–
476
484).
tap Alarms field and define the transmission bit rate:
tap Wavelength Range field and set as below:
User Manual 78000010220 Rev. 024
Figure 243 on