Stopping The Real Time Acquisition; Performing A Measurement With Smart Test - Viavi 8100 V2 Series User Manual

NOTE
During acquisition, the traffic on fiber is automatically detected (see
Detection" on page

Stopping the real time acquisition

To stop an acquisition in real time mode, press the S

Performing a measurement with Smart Test

The acquisition is carried out with the parameters saved in the Configuration file. It may
be stopped at any time using the S
At the end of test, the results page displays.
1 From the Setup page, press Start Acquisition key
measurement (see
The red Testing indicator goes on to show that the T-BERD/MTS is in process of
acquisition and the screen displays the trace in process of acquisition.
2 The quality of the connection is displayed for a few
seconds (see
3 Then, a bar graph shows elapsed and remaining acquisition time.
Figure 30 Acquisition in progress in Smart Test
56)
Figure 17 on page
Table 3 on page
Elapsed Number of
acquisition averages
time calculated
User Manual
Chapter 3 Reflectometry measurements
TART
/S key.
TART TOP
30).
56)
Elapsed Total acquisition
time time
78000010220 Rev. 024
Performing OTDR acquisitions
/S key at any time.
TOP
to launch
"Traffic
59