Configuration In Test Auto Mode - Viavi 8100 V2 Series User Manual

Chapter 3 Reflectometry measurements
Configuring the reflectometry test
Consolidated
Report naming
Select Report naming parameter and press the right arrow key to modify the name of
the report file for the result trace.
In the edition keypad, enter a name manually for the file and press Enter to validate.
Include Microscope Image
In the report page, an image of the scope test result can be displayed on the upper part
of the report. Select Yes to include the scope test result image into the report.
NOTE
This parameter is not available if the report format selected is a Txt file.

Configuration in Test Auto mode

The Test Auto
of results defined as default settings in factory.
A Acquisition
CQUISITION
Additional Pulses Setup
A Alarms
LARMS
A Parameters
NALYSIS
Measurement
52
in multi-traces display, one report page is generated for all traces
key imposes the parameters for acquisition, measurement and display
User Manual
Laser
Acquisition Mode
Time
OTDR Connector Test
Launch Cable
Short Pulse
Alarm Level
Section Attenuation
Section Length
Index of Refraction
Scatter Coefficient
Results on trace
Event Notes
OTDR Connector Meas
Splice
78000010220 Rev. 024
All
Auto
Auto
Yes & Cont
No
No
None
dB/km
Yes
G652 G657
Auto
Graphics
No
No
Auto