Creating A Project From The Setup Page - Viavi 8100 V2 Series User Manual

Chapter 3 Reflectometry measurements
Enterprise-SLM Software option (T-BERD/MTS-6000A V2 only)
Figure 59 Select Project file
4 Press Open Project menu key.
The Project displays, with a list of labels to be tested.
5 Click on the label arrow to open the list of fibers to be tested for this label.
NOTE
In Simplex mode, only the label is available as it represents the single fiber.

Creating a project from the Setup page

Once the OTDR Enterprise icon is validated, the results page automatically opens:
1 Press S
2 Load the file ENTERPRISE_Custom-list SmartConfig™
3 Modify setup menus (Acquisition, Alarms, Site Info Labels and File) if needed.
4 In the Site Info Labels menu, make sure the Fiber count parameter is defined
according to the network configuration:
–
–
–
See "Fiber Count (mandatory for project creation)" on page
116
button to open the Setup page.
ETUP
Simplex: generate a project for one single fiber test
Duplex: generate the project for double fiber test
MPO: generate a project for MPO cables
User Manual 78000010220 Rev. 024
111.