Advanced functions in Expert OTDR mode
Several actions on trace displayed can be performed in Expert OTDR mode only.
Automatic measurement and detection
If the instrument does not detect all the expected events, additional manual measure-
ments can be carried out.
To delete all the markers, press the
The following procedure is recommended:
1
By default, the instrument locates the events and proceeds to the measurements.
2
Addition of events (see
showing low attenuation and of close events. The T-BERD/MTS then automati-
cally measures the slope before and after the markers selected and measures
the attenuation of the splice.
3
Addition of manual measurements if necessary (for deeper analysis). The T-
BERD/MTS performs the measurements requested by the user.
To start an automatic measurement while a measurement is already in progress:
1
Press the
2
Press the Modify Meas. menu key
3
Select
4
Select
Addition of events
You can also manually place markers in addition to those positioned automatically
during automatic measurement.
Representation of the events
The events are represented by the symbol
The events are represented by the symbol
mode.
To add markers of events:
"Addition of events" on page
Advanced
key.
Delete
and press validation key
Auto Meas.
and press validation key
User Manual
Chapter 3 Reflectometry measurements
Advanced functions in Expert OTDR mode
Advanced
key, then select Modify Meas. > Delete.
.
: if they are set during a measurement.
if they are set manually in Advanced
78000010220 Rev. 024
85) in the cases of splices
.
85