Table of Contents
Advertisement
Note: to decrement the number, enter the sign «-» before the number. Example: -
1.
Min: -999 / Max: 999 / Auto: 0
No
the Fiber number must not automatically modified.
Extremities are different
In some cases, it is interesting to save different information for the origin and the
extremity of the cable.
If this option is validated, it is possible, after selecting the extremity to be edited in the
Cable Structure
menu, to modify the values specific to the cable (cable name, color
coding, content of the coding), for each of these extremities. See chapter
ture" on page
45)
To display/modify the data specific to the fiber (name and code), it is necessary to
change direction temporarily. In the "O->E" direction, the information on the origin can
be edited, and in the "E->O" direction, that on the extremity.
Cable Id
This parameter allows to enter an identification of the cable, using the Edition menu.
Direction
The direction shows if the acquisition has been made from the origin to the extremity (A-
>B) or from the extremity to the origin (B->A). Changing direction makes it possible,
when different extremities are handled, to see the parameters of the fiber for the other
extremity.
Location A
The name of the Location A of the link may be entered here.
Location B
The name of the Location B of the link may be entered here.
Cable structure
This line opens a sub-menu, all the parameters of which can be different for each
extremity.
User Manual
Chapter 3 Reflectometry measurements
Configuring the reflectometry test
78000010220 Rev. 024
"Cable struc-
45
Advertisement
Table of Contents
Troubleshooting
