Chapter 10 Polarization Mode Dispersion Measurement
Performing a PMD measurement with a PMD test module
•
81BBS1A
•
81BBS2A
The following procedure considers the use of an OBS-5xx type source.
Remote operator
1
Inspect and clean connectors with appropriate methods as described in IEC
61300-3-35
2
Connect the fiber under test to the optical connector of the broadband source
using required mating solution such as a fiber patchcord.
3
Press the O
4
Press Laser On/Off of the OBS-55 or the "Active" button of the OBS-5x0 to acti-
vate the source transmission.
NOTE
Make sure the test mode is set to "PMD" when using the OBS-500 or OBS-
550.
Local operator
1
Inspect and clean connectors with appropriate methods as described in IEC
61300-3-35
2
Connect the fiber under test to the optical connector of the test module using
required mating solution such as a fiber patchcord, as shown in
3
Select the PMD function in the Instrument Setup menu and wait for the module
self calibration (tuning).
4
Press the S
5
Select the appropriate PMD parameters according to your application as defined
earlier in this chapter.
6
Press the S
342
/O
button to switch on the OBS-5XX broadband source.
N
FF
button to access the PMD Test Setup menu.
ETUP
/S
button and wait for the results to be displayed.
TART
TOP
User Manual
78000010220 Rev. 024
Figure
170.