Chapter 3 Reflectometry measurements
Configuring the reflectometry test
Figure 17
Smart TestSetup page
•
Laser
•
Distance unit
•
Launch cable
30
The acquisition will be carried out on the wavelength(s)
selected (for multiple-wavelength modules). In case of a multi-
wavelength module, select All to perform a measurement for
all the wavelengths available (this parameter visible exclusively
on modules with one single OTDR port). The possible values
depend on the module used.
select the unit to be used for distance (km / kfeet / miles /
meter / feet / inch).
Define if the Launch Cable must be taken into account for the
acquisition: No / Yes.
If Yes is selected, set the length clicking on Set Length and
enter the distance using the numeric keypad. Click on
validate (or on
User Manual
to cancel)
78000010220 Rev. 024
to