Osa Optical Spectrum Analyzer Setup - Viavi 8100 V2 Series User Manual

A beep is emitted to validate the selection of the configuration file.
The software automatically brings you back to setup page.
NOTE
Most of the configuration files are available into the Platform in disk/con-
fig/IPMD.

OSA optical spectrum analyzer Setup

To configure the Platform 8000 in preparation for an OSA test on a fiber,
1 Press the S
The various measurement parameters are proposed
2 Select the parameter Mode and set it to WDM/OSNR
WDM / OSNR
WDM / OO-OSNR
DFB
I-OSNR 40G DP-QPSK
3 Define your own configuration
The parameter to be modified must be selected by means of the direction keys
using the touchscreen. The possible options then appear on the screen: make your
choice using the direction keys or touchscreen.
The various parameters proposed are defined below.
button.
ETUP
Module is used to measure the optical spectrum of an optical signal
and the OSNR, using the interpolation method. Standard WDM
results are displayed in the results table. (See
OSA results" on page
Module is used for measuring the optical spectrum of an optical
signal and the OSNR is measured by the two step On-Off method.
Standard WDM results are displayed in the results table. (See
chapter "On/Off-OSNR Method" on page
Module is used to analyze results from a DFB. DFB results are
displayed in the results table (See
page 402).
Module is used to acquire the optical spectrum of Dual polarization
40G signals (40G DP-QPSK) and to measure the In Band OSNR.
Standard WDM results are displayed in the results table. (See
"Display of the WDM / OSA results" on page
User Manual
Chapter 12 High Resolution OSA Measurement
Configuration of the instrument
390)
"DFB results analysis" on
78000010220 Rev. 024
"Display of the WDM /
400)
390).
or
383