Viavi 8100 V2 Series User Manual page 169

Base Station Id or Headend Id (in case of DAS)
If known, enter the name of the Base Station using the edition keypad, displayed
pressing the right arrow key.
NOTE
The name of Location A entered in ExpertOTDR configuration is displayed
by default in this parameter (see
RRU Id or Remote End Id (in case of DAS)
If known, enter the name of the RRU/RRH (Remote Radio Unit / Head) using the edition
keypad, displayed pressing the right arrow key.
NOTE
The name of Location B entered in ExpertOTDR configuration is displayed
by default in this parameter (see
Fiber Code / Fiber Num
To use the Fiber Code convention, with Rx/Tx labeling, choose between the following
config files: FTTA_Rx_Tx.SM-OTDR or FTTA_Rx_Tx.MM-OTDR.
For a simple labeling of the fiber number (1 to 24), load one of the following config files:
FTTA_Simple.SM-OTDR or FTTA_Simple.MM-OTDR
Example of fiber code in:
• Construction mode (with loopback): from 1-Rx_1-Tx to 24-Rx_24-Tx
• Maintenance mode: from 1-Rx to 24-Rx
Change Fiber Nbr
Select if the fiber number must be automatically Incremented or Decremented at each
new file save.
Increment the fiber number is automatically incremented at each new file-save.
Decrement the fiber number is automatically decremented at each new file-save
User defined Use Edit Number softkey to enter the increment/decrement value for
fiber number.
Note: to decrement the number, enter the sign «-» before the number. Example: -
1.
User Manual
Chapter 3 Reflectometry measurements
"Location A" on page
"Location B" on page
78000010220 Rev. 024
FTTA-SLM option
45).
45).
133