Table of Contents
Advertisement
1
Composite power
2
Channel alarms
Max channel offset
Min. channel power
Max. channel power
5
Min. OSNR
Channel Number
Channel value
6
Delta F / Delta WL
7
P Min.
8
P Max.
OSNR
Zoom Mode
The OSCA module performs a measurement over the sweep range, but the display
shows the part defined by the Zoom mode.
Auto
Full
For sweep range = FULL, it is possible to display the same wavelength range for every
new sweep, independent of previous settings of the zoom function on the result page:
C Band
Start/ End
1.Maximum composite power
2.Wavelength drift. Selection of the alarm on the basis of the value of delta F
3.The values are then defined in Min. P
4.The values are then defined in Max. P
5.The values are then defined in Min. SNR
6.Delta of frequency or wavelength
7.Minimum power
8.Maximum power
Chapter 9 OSCA-710 Optical Spectrum Measurement
No or threshold modifiable from -59.9 dBm to +20 dBm
2
No/Freq/Wavelen.
3
Yes/No
4
Yes/No
Yes/No
From «001» to the max. number of channels.
Display of the wavelength of the channel number selected
From 0 to 2 THz (2 THz is the default value) or from 0 to 8 nm.
The unit depends on the value of the parameter Max channel
offset
From -80 dBm to +9.9 dBm (below max. threshold)
From -79.9 dBm to +10 dBm (above min. threshold)
From 0 to 50 dB
display automatically zooms into the wavelength range where
optical channels are present
display full sweep range or part chosen by the zoom function of
the result page
1530-1565nm
manually selectable start / end wavelengths
User Manual
OSCA optical spectrum analyzer Setup
78000010220 Rev. 024
317
Advertisement
Table of Contents
Troubleshooting
