Table of Contents
Advertisement
Chapter 13 Attenuation profile
Recommended equipment
Recommended equipment
To perform a AP measurement, the following equipment is recommended:
•
Platform 8000 V2 with a module as referenced above, and required optical
connector.
•
OBS-5XX,the BBS1A or BBS2A with required optical connectors.
•
Fiber inspection scope with associated optical connector tips.
•
Cleaning kit.
•
Two fiber patchcords with required optical connectors.
•
One mating adapter.
AP Activation and self calibration
1
Validate the
2
Press R
informs of the progression status of the calibration at the bottom of the screen.
Wait for the calibration to be fully completed before continuing.
3
Press S
Loading a configuration file
To load the configuration file to be used for AP test:
1
Press S
2
On bottom right of setup page, press Load Config. menu key.
3
In the Explorer, select the desired file configuration
4
Press
A beep is emitted to validate the selection of the configuration file.
The software automatically brings you back to setup page.
NOTE
Most of the configuration files are available into the Platform in disk/con-
fig/AP.
408
AP
function in the Instrument Home page.
to display the auto-calibration status. A bar
ESULTS
to access to the configuration menu for AP analysis.
ETUP
hard key.
ETUP
Load
Config. menu keys.
User Manual
78000010220 Rev. 024
tuning in progress
Advertisement
Table of Contents
Troubleshooting
