Setting The Test Parameters - Viavi 8100 V2 Series User Manual

Portable, modular platform designed for the construction, validation and maintenance of optical fiber networks

Hide thumbs Also See for 8100 V2 Series:

Table of Contents

If a new folder is needed, go to step 3, else go to next section.

Highlight desired main folder. Press the soft key Create Directory to create a

sub-directory.

A virtual keyboard will appear to allow you to input a new folder name. Alterna-

tively, you can connect a USB keyboard to input the name.

You must name the folder after your site name (ex: Jones, MSC, Valley View,

Once the folder name is input, press Enter to validate and create.

All test files will be saved into this directory, unless a new one is created or the

selection of the target directory changes.

It is not mandatory to create a subdirectory as the script automatically cre-

ates one at the start of the test sequence.

Setting the test parameters

Setting the Fiber Complete (FCOMP) test parameters on

Go to the FCOMP tab

Configure the FCOMP Setup parameters as below:

FiberComplete setup

Fiber Characterization Test Sequence in Manual mode

key to get access to the setup menu

Chapter 17 Fiber Characterization

78000010220 Rev. 024