Front OTDR connector
Merged connectors
•
Zone 2: Link Table, which gives a summary of results for each wavelength, with
results within/without thresholds in green/red (according to Alarm thresholds
defined in the setup screen).
•
Zone 3: Alarms table (if any)
Show the detailed information of one event
The information concerning the event, its type and the alarm thresholds defined for this
event, can be displayed from the SmartLink screen.
1
Select the event for which information must be displayed, on the graphic using
the touchscreen or direction keys.
The event is highlighted in yellow once selected.
2
Click on the Event Diagnosis menu key.
A small window displays. It describes:
–
the event type
–
the value above which it is on defect
–
the possible causes of the alarm
Figure 45
Event Diagnosis
User Manual
Chapter 3 Reflectometry measurements
78000010220 Rev. 024
Results display
81