Perform The Ap / Cd Referencing On The T-Berd/Mts 8000 V2; Fiber Characterization Test Sequence In Manual Mode; Fiber Characterization With Fc1 Test Kit (Unidirectional) - Viavi 8100 V2 Series User Manual

Perform the AP / CD referencing on the T-BERD/MTS
8000 V2
1 Touch the AP / CD tab and press the hard key.
2 Press the soft key Acq. Ref. to enter the reference menu.
3 Select Make Reference to Yes.
4 Press Yes to confirm making a new reference.
5 Drop down using the navigation keys, or touch the BBS Serial Number param-
eter, and enter the OBS5x0 serial number using numerical keyboard and press
Enter.
NOTE
The serial number can be found at the back of the OBS5x0 handheld.
6 Press the soft key Close Ref. Menu to exit the reference menu.
7 Press the S
Fiber Characterization Test Sequence in Manual
mode
There are two modes of performing a Fiber characterization in manual mode:
• In Unidirectional mode: one OTDR measurement is performed in one way (A ->
B), using 1 x 8000 + OBS.
• In bi-directional mode: the OTDR measurement is performed in the two directions
(A -> B and B -> A), with addition of bi-directional IL/ORL using 1 x 8000 + 1 x
6000.
Fiber Characterization with FC1 Test Kit
(Unidirectional)
Once the necessary referencing measurements have been done, a fiber characteriza-
tion can be performed, in manual mode, using a T-BERD 8000 V2 at one end and an
OBS 5x at the other end.

Fiber Characterization Test Sequence in Manual mode

/S hard key to reference.
TART TOP
User Manual
Chapter 17 Fiber Characterization
78000010220 Rev. 024 469