Factory References - Viavi 8100 V2 Series User Manual

Chapter 7 FiberComplete Modules
Establishing References
Connect the jumper from the module port to the non-reflective termination via a
mating sleeve. If you don't have a non-reflective termination a mandrel can be
used. Press Ok to start referencing.
See Figure 126 on page 223
3 For the loss reference, connect the jumper from the module port of the primary
unit, toward the module port of the secondary one via a mating sleeve. Press Ok
to start referencing.
NOTE
The side-by-side loss reference is bidirectional and performed automatically
on both units.
Figure 127 Loss Reference

Factory References

In the Take Refs sub-menu, the softkey Factory Refs is available.
It allows to apply the reference values defined by default in factory.
The following figure show the values defined by default in factory:
224
Mating sleeve
Jumper
User Manual 78000010220 Rev. 024