Chapter 3 Setup And Installation Upon Receipt; Unpack The Device; Verify Contents; Inspect The Device - Viavi mA-3011 Operation Manual

Chapter 3 Setup and Installation

Upon Receipt

Upon Receipt
This section identifies tasks that should be preformed when the module is received from
the factory.

Unpack the Device

Specially designed packing material protects the device during shipping. Avoid damaging
the shipping container and packing material when unpacking the device; if necessary the
shipping container and packing material can be reused to ship the device.
CAUTION
This device is ESD sensitive and should only be unpacked by qualified personnel.
Mise en Garde
Cet appareil est sensible aux DES et il doit seulement être déballé par un personnel
qualifié.
How to Unpack the Module
1
Cut and remove sealing tape on top of shipping container.
2 Open shipping container. Remove foam insert and module from shipping container.
3
Remove module from between foam inserts.
4 Remove module from ESD protective packaging.
5
Store packing material and shipping container for possible future use.
NOTE
Refer to Packing Procedure for information and instructions for shipping the module.

Verify Contents

Refer to packing list to verify shipment is complete. Report any discrepancies to VIAVI
Customer Service.

Inspect the Device

Inspect the device for possible damage incurred during shipment. Report any damage to
VIAVI Customer Service.
Page 3-2
mA-3011 AXIe Embedded Host Module Operation Guide Rev. C0
May 2020