Table of Contents
Advertisement
Bi-directional OTDR
Chapter 6
This chapter describes the different steps to perform an automatic bi-directional
measurement (also called OEO measurement = Origin-End-Origin).This measurement
requires that two T-BERD/MTS-8000 V2 or 6000(A) are connected at each extremity of
the fiber under test. Every MTS/T-BERD must be equipped with the software option
called «OEO-OTDR» and with both optical talkset and OTDR module.
It is strongly recommended that the same type of OTDR is used (same
reference) at each extremity of the fiber.
The topics discussed in this chapter are as follows:
•
"Definition of terms used" on page 196
•
"Description of the measurement" on page 196
•
"Configuration of bi-directional measurement" on page 198
•
"Performing a bi-directional measurement" on page 200
•
"Trace display functions" on page 205
•
"OEO Result table" on page 207
•
"Automatic measurement and addition of markers in OEO page" on page 207
•
"Test of a cable" on page 208
•
"Saving the traces and generating a report" on page 209
•
"Troubleshooting" on page 213
User Manual
78000010220 Rev. 024
6
195
Advertisement
Table of Contents
Troubleshooting
