Powering The Module; Power On Procedure; Power Down Procedure; Bios Setup - Viavi mA-3011 Operation Manual

Powering the Module

Power On Procedure

The Module is powered on during the Chassis's power up process. When the Chassis is
powered on, power is routed from the AC power supply to the Module via the module's
connection to the Chassis Backplane. To ensure proper module identification and
enumeration, do not change external connections or interrupt the Chassis's power up
process. Refer to Chassis user documentation for the Chassis power up procedure.

Power Down Procedure

The Module is powered down during the Chassis's power down procedure. Refer to
Chassis user documentation for proper power down procedure.
CAUTION
Do not power down the Module by disconnecting the Chassis from the AC Power
Supply. Failure to properly power down the Module may result in lost data and/or
damage to the Module's operating system.
Mise en Garde
Ne mettez pas le module hors tension en débranchant le châssis de l'alimentation
électrique CA. Une mise hors tension inadéquate du module peut entraîner des pertes
de données ou endommager le système d'exploitation du module.

BIOS Setup

The mA-3011 BIOS settings have been set to values which allow the mA-3011 to operate
at optimal performance levels. Users should not change BIOS settings unless instructed
to do so by VIAVI AvComm Customer Service. Making changes to mA-3011 BIOS settings
may place the mA-3011, Chassis and other System components in an inoperable or
unresponsive state. VIAVI AvComm assumes no responsibility for warranty repairs related
to damages and or performance issues on devices on which BIOS settings have been
changed by the end user.
Final
March 2019
mA-3011 AXIe Embedded Host Module Operation Guide
Chapter 4 Operation and Control
Powering the Module
Page 21