Table of Contents
Advertisement
Chapter 4 Operation and Control
mA-3011 Operating System
mA-3011 Operating System
The mA-3011 Module is shipped from the factory with the operating system installed in the
module. When used as a host controller, the mA-3011 operates much like a standard
computer.
Refer to the section titled
information.
Contact VIAVI Customer Service with questions regarding supported operating systems.
NOTE
The module ships from the factory with the operating system's hibernate mode
disabled. DO NOT ACTIVATE HIBERNATE MODE: this will cause problems with the
Chassis's PCIe enumeration process.
Module Power On/Off Procedure
Power On Procedure
The module is powered on during the Chassis's power up process. When the Chassis is
powered on, power is routed from the AC power supply to the module via the module's
connection to the Chassis Backplane. To ensure proper module identification and
enumeration, do not change external connections or interrupt the Chassis's power up
process. Refer to the mA-1302/mA-1305 AXIe Chassis Operation Manual for the Chassis
power up procedure.
Power Down Procedure
The module is powered down during the Chassis's power down procedure. Refer to the
mA-1302/mA-1305 AXIe Chassis Operation Manual for proper power down procedure.
CAUTION
Do not power down the module by disconnecting the Chassis from the AC Power
Supply. Failure to properly power down the module may result in lost data and/or
damage to the module's operating system.
Mise en Garde
Ne mettez pas le module hors tension en débranchant le châssis de l'alimentation
électrique CA. Une mise hors tension inadéquate du module peut entraîner des pertes
de données ou endommager le système d'exploitation du module.
Page 4-2
"Setup Module as Host Controller" on page 3-4
mA-3011 AXIe Embedded Host Module Operation Guide
for additional
Rev. C0
May 2020
Advertisement
Table of Contents
