Table of Contents
Advertisement
Auto-set Configuration
Press Auto-set to define the PMD acquisition / analysis with the following parameters:
Acquisition
Link Description Change Fiber Nbr
Report
In
standard
Acquisition parameters
In the Setup menu, press Acquisition.
Figure 5
Acquisition parameters
NOTE
When the power of the input signal is higher than +20 dBm, a warning is dis-
played and the signal is cut off.
Chapter 2 Polarization Mode Dispersion Measurement
Sweep
Averaging acquisition
File(s) save in
Filenaming
Auto store
mode, you can set the parameters below.
User Manual
Single
Auto
Increment
[Current Dir]
[Cable_Id][Fiber_Num][Direction]
Yes
700MAN902 Rev. 000
Configuring the PMD test
9
Advertisement
Table of Contents
