Acquisition
Sweep
parameters
Continuous
Single
Statistics
Drift
NOTE
For Drift measurements a Grid needs to be defined and the Channel
Detection parameter is set to Grid.
Number of sweeps
–
–
Wait Period
The Wait Period parameter allows to enter a wait period prior to the
measurement start (in Statistics and Drift mode only).
s
Up to ...
1 minute
10 minutes
60 minutes
24 hours
MTS / T-BERD 5800 • COSA-4055 • User Manual 2016.01
There will be a measurement with refreshment of
the trace and real time display of results.
There will be one single measurement and the
display of its results.
In this mode, the number of samples concerned by
statistics must be entered (next parameter).
For measuring power and wavelength over time.
The number of sweeps and the latency between
the sweeps need to be set.
In Statistics mode: between 2 and 1000
In Drift mode: between 2 and 10000
Chapter 1 Optical Spectrum Measurement
Increments of ...
5 seconds
1 minute
5 minutes
1 hour
Configuration
11