Show Arp - Dell C9000 Series Reference Manual

show arp

Display the ARP table entries learned on a switch CPU.
C9000 Series
Syntax
show arp [cpu [cp | rp]] [interface interface | ip ip-address
[mask] | macaddress mac-address mask] [static | dynamic] [summary]
Parameters
cpu cp
cpu rp
interface interface
linecard slot-id
ip ip-address
mask
macaddress mac-
address mask
(OPTIONAL) Enter the keywords cpu cp to display the ARP
entries learned on the Control Processor.
(OPTIONAL) Enter the keyword cpu rp to display the ARP
entries learned on the Route Processor.
To specify an interface, enter one of the following interface
types and slot/port or number information:
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword port-
channel then a number. The range is from 1 to 4096.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.
• For a port extender (PE) Gigabit Ethernet interface, enter
the keyword peGigE then the pe-id/ stack-unit unit
number /port-ID information.
(OPTIONAL) Enter the interface port-type slot/port
parameters to display the ARP entries learned on a Z9500 port.
The range of slot IDs is from 0 to 2.
(OPTIONAL) Enter the keyword ip with an IP address in the
dotted decimal format to display the ARP entries learned with
this IP address. Enter the optional IP address mask in the slash
prefix format (/ x).
(OPTIONAL) Enter the keyword macaddress with a MAC
address in nn:nn:nn:nn:nn:nn format to display the ARP entries
learned with this MAC address. Enter the optional MAC address
mask in nn:nn:nn:nn:nn format also.
IPv4 Routing 1209